المجلة الدولية للبحوث الهندسية: Recent submissions

  • Developing an Empirical Correlation between DCPT Test Results and Relative Compaction for Sandy soils 
    fauzi Jarush; Abdelghani A. Asalai; Hadi Z. Tumi (Faculty of Engineering, University of Tripoli, Tripoli, Libya, 2024-10-01)
    The dynamic cone penetrometer (DCPT) is a simple portable in-situ testing instrument. It is usually used to measure the resistance of cohesionless granular soil. An attempt has been made to find a correlation between the ...
  • Field proving of a liquid displacement meter using Bi-directional Pipe Provers in Custody Transfer applications; case study of Libyan Zueitina Oil Port 
    Essa Shawail; Magdi Buaisha (The General Directorate of Inspection and Measurement -National Oil Corporation (NOC), Tripoli, Libya2Department of chemical engineering, university of Sirte, Libya, 2024-10-01)
    In this paper, a field study is conducted on proving a positive displacement meter with bi-directional pipe provers to determine the repeatability of the meter's generated pulses and the deviation of the Meter Factor ...
  • Evaluating Geotechnical Engineering Properties of Sandy soil using Granulate Waste Tires 
    fauzi Jarushi; Abdullah Talibullah (Faculty of Engineering, University of Tripoli, Tripoli, Libya2Libyan Academy for Postgraduate Studies, Janzour,Libya, 2024-10-01)
    Used tires and scrap materials is environmental issue, cause and contribute to economic difficulties. It was necessary to find a safe ways to reduce the harm. This study was to investigate the impact of granulate waste ...
  • Project Management Planning to Increase Company Resource Efficiency and Effectiveness in Indonesia 
    Almahadi Abdeljalil; Faraj Abdeljalil (Academic Studies Department, Higher Institute of science & technology, Sirte, Libya2Transportation Project Board, Tripoli, Libya, 2024-10-01)
    This study aims to develop global project management activities in the form of Work Breakdown Structure (WBS) and create project scheduling with Activity On Arrow (AOA) diagrams and barchart/gannt chart. So that with the ...
  • Predicting the strength of a plastic waste reinforced clay-sand soil mixture using BPNN approach 
    Galal Senussi; Thikra K. Abdullah; Sundus S. Omar (Department of Mechanical Engineering, Faculty Engineering, Omar Al Mukhtar University, Libya 2Department of CivilEngineering, Faculty Engineering, Omar Al Mukhtar University, Libya 3Department of Civil Engineering, Faculty Engineering, TobrukUniversity, Libya, 2024-10-01)
    The study aimed to improve soil engineering properties by incorporating waste plastic bottle strips into the soil to enhance its strength. Plastic sheets of varying sizes an percentage were used, and a Back Propagation ...
  • Design and Implementation of an Innovative Balun Configuration for Planar Antenna Use 
    Younus Mohammed (Sirte University, Sirte, Libya, 2024-04-01)
    The main parts of balanced circuits, including push-pull amplifiers, balanced mixers, frequency multipliers, and antennas, are baluns. Due to the increased integration of most of these applications, baluns must be inexpensive ...
  • A Comparative Study of Field Oriented and Backstepping Control Strategies for Wind turbine PM Synchronous Generator 
    Mohammed Khatab; Aiman Nouh; Ali. S. Abd-Alraheem (Omar Al-Mukhtar University, Faculty of Engineering, Department of Electrical and Electronics Engineering, 2024-04-01)
    In this paper, a comparative study of Field Oriented Control and Backstepping Control methods has been conducted to control a Permanent Magnet Synchronous Generator for wind power application. These control strategies are ...
  • Performance Analysis of Awbari Gas Turbine Power Plant with Crude Oil 
    Mahdi Algool; Salih Alsadaie (Mechanical Engineering Department, Faculty of Engineering, Sirte University, Sirte, Libya2 Chemical Engineering Department, Faculty of Engineering, Sirte University, Sirte, Libya, 2024-04-01)
    The performance of a gas turbine can be evaluated by its efficiency and net power output which both are affected by ambient conditions (atmosphere air temperature and humidity) and used fuel.In this work, the performance ...
  • The effect of austenitizing temperature on thenormalising processing behaviour of 34CrNiMo6 steel 
    Nasar Abdlssalam Ali; Mahdi Algool (Sirte University, Faculty of Engineering, Mechanical Department, Sirte, Libya, 2024-04-01)
    The aim of this study is to carry out research about the effect of austenitizing temperature of 34CrNiMo6 low alloy steel on the normalising heat treatment process. Moreover, a comparison of the austenite grain size that ...
  • A Microcontroller-Based Face Recognition Attendance System 
    Abdulkarim Gharib; Essam Abusamra (Electrical Engineering Department, High Institute of Science and Technology, Sirte, Libya, 2024-04-01)
    Attendance management system is an indispensable system by which every organisation tracks employees or students attendance. The manual process of marking attendance by using a paper-based or file-based system is susceptible ...
  • Spiral Microstrip Bandpass Filters 
    Ghaith Mansour; Mohammed Elmahdi; Ekasit Nugoolcharoenlap (Department of Electrical and Electronic Engineering, Faculty of Engineering, Sirte University, Libya2Department of Telecommunication Engineering, RajamangalaUniversity of Technology Rattankosin (RMUTR), Thailand, 2024-04-01)
    Microstrip bandpass filters based on spiral resonators are designed at 700MHz for 5G applications. In order to achieve size reduction, spiral resonators are used. The proposed filters are of third and fifth orders. The ...
  • Bearing Misalignment and Eccentric Wear: A Study on Condition Monitoring 
    Saleh Emtaubel (Faculty of Mechanical Engineering, Omar al-Mukhtar University, al-Bayda, Libya2Faculty of Mechanical Engineering, Omar al-Mukhtar University, al-Bayda, Libya, 2024-04-01)
    This study investigates ball bearing failures and evaluates the performance of various methods for detecting such failures. Experimental tests were conducted on a motor-generator system supported by ball bearings, where ...
  • Effect of variable parameters on the performance of gas turbine cycle 
    Mahdi Algool; Nasar A. O. Ali; Salem Elokalli (Mechanical Engineering Department, Faculty of Engineering, Sirte University, Sirte, Libya2Raslanuf Company, Sirte, Libya, 2023-12-02)
    The gas turbine are being usually used in several application such as aircraft engine and electricity power station plants. To improve its performance many researches has been performed. In this study the thermodynamic ...
  • Calculating the Ultimate Bearing Capacity of a Strong Soil Layer over a Weak Soil Layer 
    Maha A. A. Shanaa (Civil Engineering Department, Higher Institute of Science and Technology,Sirte,Libya, 2023-12-02)
    The ultimate bearing capacity calculations for shallow footings in two-layered soil systems hinge on the underlying failure surface pattern. his study examines scenarios observed in nature, where strong soil overlays a ...
  • الكشف عن وتشخيص أورام المخ باستخدام الشبكات العصبية التلافيفية 
    عبد القادر الربعي (Physics Department, Education Faculty –Wadi Alshatti University, Libya, 2023-12-02)
    Brain tumors are one of the major health problems related to abnormalities in the human brain. An activist diagnosis of brain tumors is critical to improve patient outcomes and lives. Early detection of tumors is crucial ...
  • Impacts of U and Inverted U-Bends on Vertical Gas-Liquid Two-Phase Fluids 
    Almabrok Abushanaf Almabrok (Petroleum Engineering Department, Faculty of Engineering-Sirte University, Sirte, Libya, 2023-01-01)
    The current work is experimentally based which is conducted on the purpose of studying the impacts of U and inverted U-bends on gas/liquid behavior in a vertical upward and downward flow line. The main instruments used are ...
  • Cloud Computing and Artificial Intelligence: A Scoping Literature Review 
    Naiema M.A. Mohamed (Computer Department,Faculty of Information Technology,Sirte University, Sirte, Libya, 2023-01-01)
    In the past two decades, Cloud Computing (CC) and Artificial Intelligence (AI) technologies have witnessed amazing growth, and the majority of organizations and companies around the world have become more aware of the ...
  • Electromagnetic Radiation Measurements from Mobile Base Stations in Sirte 
    Fatma Shkal (Faculty of Engineering, Electrical and Electronics Department, Sirte University, Sirte, Libya, 2023-01-01)
    The main objective of this work is to evaluate the power radiated from mobile base stations by measuring the power density of chosen base stations on particular schools and sites of local communication networks in Sirte ...
  • Elliptic Aperture Coaxial Sensor 
    Mabrouka Haiba A. Ehtaiba (Faculty of Engineering, Electrical and Electronics Department, Sirte University, Sirte, Libya, 2023-01-01)
    Flat open-ended coaxial sensors are increasingly popular for numerous measurement techniques, as a non-destructive method, due to the increased sensitivity and contrast obtained at microwave frequencies. The flat aperture ...
  • Graduates Skills Developments for Libyan Labour Market 
    Mohamed Edali; Walid Alaswad; Asma Milad; Ali Bseibsu; Tareq Alajaili; Zaed Sahem; Faraj Ben Rajeb; Ali Elkamel (1, 2, 3, 4 Department of Chemical and Petroleum Engineering, Elmergib University, Elkhoms, Libya5 Department of Management, Faculty of Commerce, Elmergib University, Libya1, 6 Creativity Group, Ottawa, Canada7 Department of Oil and Gas Engineering, Memorial University, St. Johns, Canada8 Department of Chemical Engineering, University of Waterloo, Waterloo, Canada, 2023-01-01)
    Any educational program's outcomes can be described in terms of both knowledge and skills. Chemical engineering graduates' skills and abilities might include those unique to managing material and energy balances and ...

Search DSpace


Browse

My Account